Microcontroller Atmel MCS51

ROM used Atmel microcontrollers MCS51 including types of Flash PEROM (Eraseable Programmable Read Only Memory). Atmel MCS51 microcontroller can be considered as Flash PEROM if RST (pin 9) were given at 5 V, and (pin 29) is connected to Ground. In such circumstances, port 0 functions as a data channel (data bus) D0-D7, port 1 and port 2 PSEN portion (P2.0-P2.5) serves as a channel address (address bus). For a 20-foot version of the microcontroller chip is already equipped with the address counter, which serves as the address bus instead. The value of the address counter will go up one whenever there is a positive pulse applied to the leg XTAL1.
electrocampus.blogspot.com

As Flash PEROM then the memory-program the microcontroller to do some of the following:

1. Delete the contents of Flash PEROM at once
2. Fill Flash PEROM byte per byte
3. Read and take the contents of Flash PEROM byte per byte
4. Perform lawyer-identifikasian signature bits in the respective microcontroller
5. Perform locking of the Flash PEROM, which provided three kinds of locking for versions 40 feet wide and 2 feet locking for version 20

Table Mode Flash Programming MCS51 PEROM

electrocampus.blogspot.com

To do opersi-operation as mentioned above on Atmel MCS51 microcontroller requires a signals to be supplied as Flash programming mode PEROM. Atmel's microcontroller MCS51 40-foot version of these signals are given to the feet of P2.6, P2.7, P3.6 and P3.7. For a mini version (20 feet) of these signals are given to the feet of P3.3, P3.4, P3.5 and P3.7. In addition to these signals should also set the voltage applied to the foot VPP, for the purposes of charging Flash PEROM required voltage 12 V and 5 V for reading Flash PEROM accompanied by a negative pulse delivery to the leg PROG. Flash programming mode PEROM Atmel microcontroller MCS51 40-foot version shown in the table above. For a mini version (20 feet) the same programming mode simply not equipped with protection Bit 3.



Related Posts :

  • Electro Science - Types of Diodes Types of Diodes divided into several sections, ranging from Light Emiting Diode (Light Emission Diode) is commonly abbreviated as LEDs, Pho… Read More...
  • Electro Transistor A transistor is a semiconductor device that is used as an amplifier, as the circuit breaker and junction (switching), voltage stabiliza… Read More...
  • Electro Capacitor Capacitors are electronic components that hold an electrical charge for an indefinite time. Different from the accumulator capacitor store… Read More...
  • Electro Diode Diode is a semiconductor component consisting of a PN junction. Diode is a combination of two words electrodes, ie the anode and cathode. O… Read More...
  • Electro Resistor Resistor is a passive electronic component that has the ability to inhibit and limit the incoming electric current in an electronic circuit… Read More...

0 Response to " Microcontroller Atmel MCS51"

Post a Comment